Analysis of Welding Current Variation of SMAW and GTAW Combination Welding with Double V Groove on The Mechanical Properties and Microstructure of SS304 Stainless Steel

Authors

  • lia amalia Institut Teknologi Kalimantan
  • Maria Lena Sinambela Institut Teknologi Kalimantan
  • Rifqi Aulia Tanjung Institut Teknologi Kalimantan
  • Jatmoko Awali Institut Teknologi Kalimantan

DOI:

https://doi.org/10.35718/specta.v7i1.663

Keywords:

SMAW, GTAW, current variation

Abstract

In this paper, the combination of shielded metal arc welding (SMAW) and gas tungsten arc welding (GTAW) welding methods are used in a double V groove SS304 10 mm thick plate. Welding current variation of 110A SMAW/120A GTAW, 100A SMAW/130A GTAW, and 90A SMAW/140A GTAW was used to observe the effect of the welding current variation on the tensile strength and microstructure. Tensile test and metallography test were performed to observe the phenomenon. ImageJ software was used for microstructure analysis. The welding current variation resulted in higher tensile strength with the highest current on GTAW method, while a more dispersed and lathy ferrite structure was observed on the microstructure.

 

Downloads

Published

2023-05-31

How to Cite

amalia, lia, Sinambela, M. L. ., Tanjung, R. A. ., & Awali, J. . (2023). Analysis of Welding Current Variation of SMAW and GTAW Combination Welding with Double V Groove on The Mechanical Properties and Microstructure of SS304 Stainless Steel. SPECTA Journal of Technology, 7(1). https://doi.org/10.35718/specta.v7i1.663

Issue

Vol. 7 No. 1 (2023): SPECTA Journal of Technology

Section

Articles

License

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Attribution-NoDerivs 4.0 Generic(CC BY-ND 4.0) that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

Most read articles by the same author(s)